Im still deciding on an amp to power my 2 12" alpine type R's, these are the two amps ive been looking into
RMS Power 125W x 2 @ 4 Ohm
RMS Power 200W x 2 @ 2 Ohm
RMS Power 400W x 1 @ 4 Ohm MONO
Signal-to-noise ratio: 100 dB
Frequency Response: 5Hz - 50kHz
Total harmonic distortion: 0.05%
Continuously variable 0 - 18dB BASS boost
Built-in continuously variable 18dB per octave crossover
Remote bass level control “port” (remote RM-100 available separately)
Input sensitivity: 200mV - 4V
Backlit CONCEPT logo
Size: length x width x height: 300mm x 296mm x 60mm 11.82" x 11.66" x 2.37"
Output 4 Ohms: 300W x 1
Output 2 Ohms: 600W x 1
Signal-to-Noise (dBA): >100
Frequency Response (±3dB): 20Hz - 500Hz
Total Harmonic Distortion: 0.1%
Input Sensitivity: 250mV - 4V
are these to amps about the same power range or would one over power the other??
and which one would you use????