Closed Thread
Results 1 to 7 of 7

Reload Thread: any one know of a 5 ch amp that has 100w x 4 + 150w x 1?

  1. #1
    bum's Avatar
    bum
    bum is offline Member



    Join Date
    Jan 2006
    Location
    usa
    Posts
    105
    Post Thanks / Like
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    Quoted
    0 Post(s)

    any one know of a 5 ch amp that has 100w x 4 + 150w x 1?

    i've been searching everywhere to no avail.

    i have 90w rms x 2 in the front stage, 80w rms x 2 in the back, and my sub is 150w rms and i'd like to hit it all with one amp.

    any ideas? best i found was 150w x 1, 85w x 4







  2. #2
    thadman's Avatar
    thadman is offline CarAudio.com Elite



    Join Date
    May 2005
    Location
    Indiana
    Posts
    1,514
    Post Thanks / Like
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    Quoted
    0 Post(s)

    Re: any one know of a 5 ch amp that has 100w x 4 + 150w x 1?

    DLS Ultimate A7

    RMS output per channel at 13,8 volts, 20 Hz - 20 kHz , < 0,1% distortion.
    Mode : AB
    Number of channels : 5
    Nominal power in 4 ohm : 4 x 60 W
    The stereo channels can be connected in bridge mode giving a power of 2 x 200 W RMS
    Nominal power in 2 ohm : 4 x 100 W
    Mono channel, nominal power in 4 ohm : 300 W
    Mono channel, nominal power in 2 ohm : 440 W
    Mono channel, nominal power in 1 ohm : 600 W
    S / N ratio, A-weighted : > 100 dB
    Damping factor : > 200
    Input impedance : > 10 kohm
    Input sensitivity, variable : 0,3 - 7 V
    Filter ch. 1 & 2 : Highpass: 80 - 400 Hz / 1,6 - 8 kHz (x20)
    Filter ch. 3 & 4 : Highpass: 80 - 400 Hz. Lowpass 0,3 - 4 kHz / 3 - 40 kHz (x10)
    Filters mono sub channel : Lowpass: 50-125 Hz.
    Terminal for external cooling fan : Yes
    Phase control : 0-180 degrees continuously
    Remote sub level control with phase shift : Yes
    Dual DC-inputs : No
    Current draw, idle : 1,1 A
    Current draw, maximum : 120 A
    Dimensions W x D x H : 605 x 240 x 73 mm (23,82 x 9,45 x 2,87 inch)
    Weight

    : 8,1 kg ( 17,86 lb)




  3. #3
    bum's Avatar
    bum
    bum is offline Member

    Threadstarter


    Join Date
    Jan 2006
    Location
    usa
    Posts
    105
    Post Thanks / Like
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    Quoted
    0 Post(s)

    Re: any one know of a 5 ch amp that has 100w x 4 + 150w x 1?

    that's 4 x 60w + 1 x 300w

    ?




  4. #4
    bum's Avatar
    bum
    bum is offline Member

    Threadstarter


    Join Date
    Jan 2006
    Location
    usa
    Posts
    105
    Post Thanks / Like
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    Quoted
    0 Post(s)

    Re: any one know of a 5 ch amp that has 100w x 4 + 150w x 1?

    ok bear with me, i'm trying to understand the 2/4 ohm thing.

    if the four speakers are wired parellel, i can get them at running at 2 ohms, meaning they will get 100w each with that amp..

    but what is the difference between running them at 4 ohms vs. 2 ohms?




  5. #5
    Bake's Avatar
    Bake is offline CarAudio.com Elite



    Join Date
    Jul 2005
    Location
    Ga
    Posts
    1,072
    Post Thanks / Like
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    Quoted
    0 Post(s)

    Re: any one know of a 5 ch amp that has 100w x 4 + 150w x 1?

    You will have to bridge the 4 channels to 2 channels and connect 2 of your speakers in parallel on each to get 100 watts to all 4 speakers. If you do this you will have to give up front to rear fading or left to right balance. I would keep left and right channels and do without fading if I were to use this type of setup. That way you keep left and right sterio channels. You will in effect have a three channel setup. One for left with two speakers in parallel one for right with two speakers in parallel and a sub channel that could be run at 4,2,or 1 ohms for 300,440 or 600 watts. You could do this with just about any 5 channel amp so that may open the field a little in terms of what is out there that you could use. Hope this helps.




  6. #6
    hks's Avatar
    hks
    hks is offline Junior Member



    Join Date
    Oct 2005
    Location
    aaa
    Age
    34
    Posts
    20
    Post Thanks / Like
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    Quoted
    0 Post(s)

    Re: any one know of a 5 ch amp that has 100w x 4 + 150w x 1?

    xetec p4 evo




  7. #7
    btnhfan's Avatar
    btnhfan is offline Hail to the King Baby!!!!



    Join Date
    Jan 2004
    Location
    CT/ GA Tech, Atlanta
    Age
    27
    Posts
    7,067
    Post Thanks / Like
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    Quoted
    0 Post(s)

    Re: any one know of a 5 ch amp that has 100w x 4 + 150w x 1?

    Memphis belle possibly

    Thats a great amp too.



    Best receiver ever?
    I think so

Closed Thread

Similar Threads

  1. setting for 4 ch amp
    By gotskill10 in forum General Discussion
    Replies: 1
    Last Post: 03-09-2005, 06:27 PM
  2. Component Speakers for 4 ch. amp
    By novaracer in forum Speakers
    Replies: 10
    Last Post: 03-06-2005, 05:01 AM
  3. Question about my 2 ch amp
    By liqdsm in forum Wiring, Electrical and Installation Help
    Replies: 1
    Last Post: 12-20-2003, 12:31 AM
  4. 4 ch amp help
    By snaphook in forum Wiring, Electrical and Installation Help
    Replies: 8
    Last Post: 10-15-2002, 09:30 PM
  5. 4 ch amp
    By phreak53 in forum Amplifiers
    Replies: 1
    Last Post: 03-31-2002, 11:58 PM

User Tag List

Posting Permissions

  • You may not post new threads
  • You may post replies
  • You may post attachments
  • You may edit your posts
1e2 Forum