i've been searching everywhere to no avail.

i have 90w rms x 2 in the front stage, 80w rms x 2 in the back, and my sub is 150w rms and i'd like to hit it all with one amp.

any ideas? best i found was 150w x 1, 85w x 4

Printable View

- 02-01-2006bumany one know of a 5 ch amp that has 100w x 4 + 150w x 1?
i've been searching everywhere to no avail.

i have 90w rms x 2 in the front stage, 80w rms x 2 in the back, and my sub is 150w rms and i'd like to hit it all with one amp.

any ideas? best i found was 150w x 1, 85w x 4 - 02-01-2006thadmanRe: any one know of a 5 ch amp that has 100w x 4 + 150w x 1?
DLS Ultimate A7

RMS output per channel at 13,8 volts, 20 Hz - 20 kHz , < 0,1% distortion.

Mode : AB

Number of channels : 5

Nominal power in 4 ohm : 4 x 60 W

The stereo channels can be connected in bridge mode giving a power of 2 x 200 W RMS

Nominal power in 2 ohm : 4 x 100 W

Mono channel, nominal power in 4 ohm : 300 W

Mono channel, nominal power in 2 ohm : 440 W

Mono channel, nominal power in 1 ohm : 600 W

S / N ratio, A-weighted : > 100 dB

Damping factor : > 200

Input impedance : > 10 kohm

Input sensitivity, variable : 0,3 - 7 V

Filter ch. 1 & 2 : Highpass: 80 - 400 Hz / 1,6 - 8 kHz (x20)

Filter ch. 3 & 4 : Highpass: 80 - 400 Hz. Lowpass 0,3 - 4 kHz / 3 - 40 kHz (x10)

Filters mono sub channel : Lowpass: 50-125 Hz.

Terminal for external cooling fan : Yes

Phase control : 0-180 degrees continuously

Remote sub level control with phase shift : Yes

Dual DC-inputs : No

Current draw, idle : 1,1 A

Current draw, maximum : 120 A

Dimensions W x D x H : 605 x 240 x 73 mm (23,82 x 9,45 x 2,87 inch)

Weight

: 8,1 kg ( 17,86 lb) - 02-01-2006bumRe: any one know of a 5 ch amp that has 100w x 4 + 150w x 1?
that's 4 x 60w + 1 x 300w

? - 02-01-2006bumRe: any one know of a 5 ch amp that has 100w x 4 + 150w x 1?
ok bear with me, i'm trying to understand the 2/4 ohm thing.

if the four speakers are wired parellel, i can get them at running at 2 ohms, meaning they will get 100w each with that amp..

but what is the difference between running them at 4 ohms vs. 2 ohms? - 02-01-2006BakeRe: any one know of a 5 ch amp that has 100w x 4 + 150w x 1?
You will have to bridge the 4 channels to 2 channels and connect 2 of your speakers in parallel on each to get 100 watts to all 4 speakers. If you do this you will have to give up front to rear fading or left to right balance. I would keep left and right channels and do without fading if I were to use this type of setup. That way you keep left and right sterio channels. You will in effect have a three channel setup. One for left with two speakers in parallel one for right with two speakers in parallel and a sub channel that could be run at 4,2,or 1 ohms for 300,440 or 600 watts. You could do this with just about any 5 channel amp so that may open the field a little in terms of what is out there that you could use. Hope this helps.

- 02-02-2006hksRe: any one know of a 5 ch amp that has 100w x 4 + 150w x 1?
xetec p4 evo

- 02-02-2006btnhfanRe: any one know of a 5 ch amp that has 100w x 4 + 150w x 1?
Memphis belle possibly

Thats a great amp too.