Tweeter Spheres - pics and examples

[keep_hope_alive]

certainly, there is a huge benefit in having some adjustment.

i just prefer the way they sound.

[InhumanAcura]

i dont know if anyone has said it in the past 8 pages, but you bore a hole in one of the those wooden balls in like 10 seconds with a milling bit rather than what i saw on the first few pages.

[keep_hope_alive]

i dont know if anyone has said it in the past 8 pages, but you bore a hole in one of the those wooden balls in like 10 seconds with a milling bit rather than what i saw on the first few pages.

i use a forstner bit now. yes, much, much, much faster.

[jdmferio13]

Can the vifa xt25s be taken apart like the outer ring? .Also you stated to make sure the sphere has a distance from the panel how much?I have an 08 civic si sedan with little windows I would like to try there.

[keep_hope_alive]

Can the vifa xt25s be taken apart like the outer ring? .Also you stated to make sure the sphere has a distance from the panel how much?I have an 08 civic si sedan with little windows I would like to try there.

i've seen those and i'm not sure how easy it is to disassemble - i assume it's the same as the faceplate-less tweeters shown above. But it is probably glued.

with the xt25 and the civic windows, it pushes you towards a pod instead of a sphere. pods with smooth transitions can also sound nice.

[jdmferio13]

So spheres would be worthless if I did them inside the windows?

[keep_hope_alive]

So spheres would be worthless if I did them inside the windows?

not an accurate statement. spheres, by definition, exist only with a stand-off. other than that, if they are molded into a panel, they are just pods. pods with smooth transitions are still good.