::TESTED:: Audiopipe AP30001D

[basscort2009]

They dont know.....

i know i usually dont argue cuz its a losing battle. but all the true spl guys know. well even some of them dont. lol. my buddy is running 14k rms and 1 18 and its not fused once lol

[mgcauctions09]

yea but take all them out and whatch ur score go up about 2-5 tenths

Actually to the volt meter it was the same so I dont see how my score would be better. I guess I have no loss due to 4 runs of positive and 4 runs of ground 2 of each per amp.

[mgcauctions09]

I agree, when it comes to competing, that is fine as you want every 1/10th you can get. As for a loud as F u c k daily driver fusing is the best option. Just add an extra run of 1/0 to make up for the loss. Thats what i did. Its a hell of alot cheaper adding 1 extra run of 1/0 then replacing vehicle,equipment or both.

[annarbor84]

Mine is daily tuned to 36hz, I have a few runs of negative and positive though also

[Bobby32]

Can I wire it to 1 ohm and be fine?

[4OZGLOVES]

Can I wire it to 1 ohm and be fine?

do you have the electrical to back it up.

[timmoore718]

I may be new on "THIS" forum, but not on others, and I couldn't agree anymore with what you said. I just bought 2, and hope to hell that there at least "decent" Im not looking for quality like my VLX400/USA800 amps, but something to hold me over till I can afford 2 DAT2500.1's or 2 SAZ3500's or something. And with all i've been reading on the internetz, they should be just fine.

pics?

[timmoore718]

Can I wire it to 1 ohm and be fine?

as previously said, the box matters a ton! I ran one of these with the same electrical at 1 ohm in two different boxes, one box worked, one didnt. if youre unsure on how to do a proper box, you could always find someone on these forums that does, or just up it to 2 ohms. gonna be louder of course at 1 ohm though

[Bobby32]

Well I have a D2 sub so I cant wire it to 2 ohm. its either 1 ohm or 4 ohm. I have a c&d battery in the back and I dont play it full tilt often. Hopefully I have a high imp rise.

[timmoore718]

Well I have a D2 sub so I cant wire it to 2 ohm. its either 1 ohm or 4 ohm. I have a c&d battery in the back and I dont play it full tilt often. Hopefully I have a high imp rise.

dam bro, with a stock alt and only that batt, good luck on 1 ohm even with the proper box

[4OZGLOVES]

I would get another c&d before i tried it at 1 ohm

[Bobby32]

I put it on 1 ohm and it doesnt go into protect. I put my pos and neg speakers wires in seperate terminal things. I dont know if I should put them side by side or keep them the way they are. It doesnt hit hard at all, all my settings are messed up. What should I have the LFP, Subsonic, freq, etc. at? Im tuned to 32hz.

[basscort2009]

subsonic at like 30-35 lpf about half. gain at about a quarter pobly. freq about 60

[Bobby32]

do you know what the settings go up to? or is that just an estimate based on all amps?

[basscort2009]

estimate based on ur setup and box tuning